Switch Firmware downgrade
It is higly recommanded to do a factory reset when downgrading firmware on Gigacore switches.
We have observed some strange behavior in this scenario
Related Articles
LumiNode firmware upgrade
In this document we will explain how to upgrade the firmware on the LumiNodes. There is only ONE firmware file for ALL the models which makes it easy to start with as there won't be any confusion about having the correct file. How to get the latest ...
Can I transport the output data of my LED controller through the GigaCore Ethernet switch?
LED controllers such as Novastar or equivalent, use a non Ethernet based protocol to transport their pixel control protocol to the LED panels. It is therefore impossible to transport this kind of protocol through any Ethernet switch, including the ...
Can I connect a Gigacore Switch to a third party switch trunk?
Absolutely! Here is what you need to know to achieve that : The Gigacore line of switches uses 20 pre-implemented VLANs that we call "Groups". The ISL Group is a trunk with all these 20 VLans tagged. Group 1 (Management) = VID : 1 Group 2 = VID : 200 ...
Using AVB on Luminex Switches - Original GigaCore line
Luminex GigaCore switches are Avnu Certified with firmware version 2.8.0 and later. All GigaCore switches, including legacy devices already installed in the field, will be capable of receiving this firmware update. No additional service charges or ...
Using AVB on Luminex Switches - New GigaCore line
No additional service charges or licenses are required to enable the AVB feature-set. This article applies to the following models : GigaCore 10i GigaCore 10t GigaCore 16i GigaCore 16t GigaCore 18t GigaCore 20t GigaCore 30i References This article ...