Can I transport the output data of my LED controller through the GigaCore Ethernet switch?

Can I transport the output data of my LED controller through the GigaCore Ethernet switch?

LED controllers such as Novastar or equivalent, use a non Ethernet based protocol to transport their pixel control protocol to the LED panels. It is therefore impossible to transport this kind of protocol through any Ethernet switch, including the GigaCore Ethernet switch series. 

    • Related Articles

    • GigaCore Gen2 API documentation

      In the attached document you can find all the web API commands available for the second generation GigaCore. The API is also available on the device itself by browsing to http://{YOUR_DEVICE_IP}/api/doc This API works for Gen2 GigaCore switches. All ...

    • LumiNode LED reference

      Luminex LumiNode LED Reference DMX Port LED States LED State Description Solid Green DMX input idle Blinking Green Active DMX input detected Solid Cyan DMX output mode (DMX only), idle Blinking Cyan DMX output activity Solid Blue DMX + RDM output ...

    • Can I transport AES50 audio protocol through the GigaCore?

      AES50 is an open standard based on the AES10 protocol (MADI) but has been developed much further. Published by the Audio Engineering Society AES, this protocol is using Cat5 cabling for transport. However, the protocol is not Ethernet compliant, this ...

    • LumiNode LED indicators

      There are various LEDs on the LumiNode. Here is a list of the LEDs, the possible colours, and the meaning of each colour: DMX Port Status Meaning DMX Input Green Blinking: Active input DMX only (output mode) Cyan Blinking: DMX activity DMX + RDM ...

    • GigaCore LED reference

      Luminex GigaCore LED Reference System Status LEDs OK / General Status LED Icon State Description Solid Green System operating normally Blinking Green Writing to flash memory, do not power off Solid Orange Temperature warning Blinking Red Temperature ...