In this document we will show how to configure your setup to run the Robe RoboSpot through your existing network infrastructure using the LumiNodes. In this setup we have one LumiNode at the base station side to create the DMX input to the system and ...
RJ45 serial pinout: Pin 4,5: GND Pin 3: RX (Data going to the GigaCore) Pin 6: TX (Data out of the GigaCore) Signal levels are RS232! Serial connection settings: Speed: 115200 Data bits: 8 Stop bits: 1 Parity: None Flow Control: None
LED controllers such as Novastar or equivalent, use a non Ethernet based protocol to transport their pixel control protocol to the LED panels. It is therefore impossible to transport this kind of protocol through any Ethernet switch, including the ...