Hardware
GigaCore 20t LCD info and symbols
GigaCore 20t LCD info and symbols When using a GigaCore 20t , the frontpanel LCD and encoder can be used to get info on the ports or quickly setup the ports of the switch. By default, the LCD will turn off after 600 seconds. This can be changed via ...
Using NDI on Luminex GigaCore switches
An introduction to NDI NDI (network Device Interface) allows for compressed, high-quality, low-latency video transmission over standard Gigabit IP networks, enabling scalable and flexible AV workflows. It supports video resolutions up to 4K and ...
SFP modules
Introduction Luminex network switches support a wide range of Small Form-factor Pluggable (SFP) modules, providing flexible and reliable connectivity for professional AV and IT applications. Choosing the right SFP module is crucial to ensure optimal ...
GigaCore Generation 2 devices
The GigaCore range of switches consist of 2 generations of products, built on different hardware platforms. The following devices are part of the GigaCore Generation 2 range of products : GigaCore 10i GigaCore 16i GigaCore 30i GigaCore 16t GigaCore ...
GigaCore Generation 1 devices
The GigaCore range of switches consist of 2 generations of products, built on different hardware platforms. The following devices are part of the GigaCore Generation 1 range of products : GigaCore 12 GigaCore 14R GigaCore 16XT GigaCore 16 RFO ...
Gigacore 10 Rack mounting hardware
The Gigacore 10 comes with all the necessary rack mounting hardware. But in case you misplaced these parts, we have put together this document with schematics and part numbers to help order new ones
Gigacore line - Noise level measurements @ 1m
GigaCore 26i Ambient Temperature Noise level @1m 0 – 30°C Max 22dBA 30 – 50°C Max 33dBA GigaCore 26i PoE PoE Total power consumption Ambient Temperature Noise level @1m <150 W 0 – 30°C Max 22dBA 30 – 40°C Max 33dBA <250 W 0 – ...
GigaCore switches Fiber Optic cabling
This document will describe how to connect all your network devices via fiber optic and what to look out for on hardware level. SFP Technical Info In order to connect all the fiber links in the correct order we need to know which side of the SFP ...
Fiber Type and Identification
Types of Fiber Fiber optic cable consists of a core surrounded by cladding. The core is the center area through which the light signals are transmitted, the cladding completely surrounds the core to stop the light from escaping. There are two types ...
GigaCore RJ45 serial Connection on the console port
RJ45 serial pinout: Pin 4,5: GND Pin 3: RX (Data going to the GigaCore) Pin 6: TX (Data out of the GigaCore) Signal levels are RS232! Serial connection settings: Speed: 115200 Data bits: 8 Stop bits: 1 Parity: None Flow Control: None