What are the default credentials of a GigaCore? (Gen 1 and Gen 2)
By default, any GigaCore switch will use the following:
Login: admin
Password: no password, leave the field blank
Related Articles
GigaCore Gen2 API documentation
In the attached document you can find all the web API commands available for the second generation GigaCore. The API is also available on the device itself by browsing to http://{YOUR_DEVICE_IP}/api/doc This API works for Gen2 GigaCore switches. All ...
GigaCore Bitfocus Companion Streamdeck module
Introduction Luminex products have an open HTTP API. This API can be used to integrate with other software applications. The GigaCore API is documented here (generation 2) and here (generation 1). One such application is Bitfocus Companion, a ...
Using AVB on Luminex Switches - Gen1 GigaCore line
Luminex GigaCore switches are Avnu Certified with firmware version 2.8.0 and later. All GigaCore switches, including legacy devices already installed in the field, will be capable of receiving this firmware update. No additional service charges or ...
Using AVB on Luminex Switches - New GigaCore line
No additional service charges or licenses are required to enable the AVB feature-set. This article applies to all GigaCore Gen2 switches. References This article outlines how to use the web interface on the second generation GigaCore switches to ...
GigaCore 20t LCD info and symbols
GigaCore 20t LCD info and symbols When using a GigaCore 20t , the frontpanel LCD and encoder can be used to get info on the ports or quickly setup the ports of the switch. By default, the LCD will turn off after 600 seconds. This can be changed via ...