Terminal block for contact closure on Luminode

Terminal block for contact closure on Luminode

Have you lost the terminal block connector of your Luminode?
The original part for the 2 pole terminal block shipped with :
  1. Luminode 2
  2. Luminode 4
  3. Luminode 12
  4. Lumicore
is :
Wurth 691 361 300 002

There are many option for this standard out there but this example will hopefully point you in the right direction to source a suitable replacement.

    • Related Articles

    • LumiNode API documentation

      In the attached document you can find all the web API commands available for the LumiNode and LumiCore. The API is also available on the device itself by browsing to http://{YOUR_DEVICE_IP}/api/doc To highlight a couple of applications that are ...

    • LumiNode/LumiCore control channel values

      In the LumiNode/LumiCore there are different functions where a control channel can be assigned. All values are in the range 0 - 255. These are the control channel values for each of the available options: General: 0 - 7: Do Nothing Switch: 8 - 15: ...

    • LumiNode / LumiCore RSTP support

      LumiNode / LumiCore – RSTP Support and Updated Redundancy Behavior Minimal firmware version: v2.8 Introduction Starting from firmware v2.8, LumiNode and LumiCore devices have full support for Rapid Spanning Tree Protocol (RSTP). This significantly ...

    • LumiNode firmware upgrade

      In this document we will explain how to upgrade the firmware on the LumiNodes. This can be done in two ways: using Araneo (recommended) or using the web interface of the LumiNode. Araneo Araneo allows upgrading multiple LumiNodes or LumiCores at the ...

    • LumiNode Advanced Networking

      In this article we will look at how to configure the network and advanced network options of the LumiNode. Firmware 2.3.0 or higher is required for these features. The interface has been redesigned in firmware 2.5.0. Note: It is not recommended to ...