SNMP / RMON on Gigacore switches

SNMP / RMON on Gigacore switches

Gigacore switches offer SNMP based on the RMON standard (RFC 1757)

You can find detailed documentation on the standard here : https://oidref.com/1.3.6.1.2.1.16

That being said, it is usually automatically detected in major software like PRTG.


    • Related Articles

    • GigaCore supported SNMP OIDs (Gen 1 and Gen 2)

      This article describes the OID's supported by the GigaCores that return relevant info. - SNMP must be enabled on the GigaCore switches, either via Arano, or the WebUI, as it is disabled by default. - GigaCores use SNMP V1 and V2c. - The default ...

    • Luminode SNMP MIB Details

      The Luminode range of products has SNMP capabilities. Here is a list of all the OID enabled in the MIB : System information .1.3.6.1.2.1.1.1 : system description .1.3.6.1.2.1.1.2 : object ID .1.3.6.1.2.1.1.3 : Uptime .1.3.6.1.2.1.1.5 : System name ...

    • GigaCore Gen2 API documentation

      In the attached document you can find all the web API commands available for the second generation GigaCore. The API is also available on the device itself by browsing to http://{YOUR_DEVICE_IP}/api/doc This API works for Gen2 GigaCore switches. All ...

    • Gigacore Switches and Avid S6L

      As most of you probably know by now, Gigacore switches can be used to connect the different units in an Avid S6L system. The procedure to configure Gigacore switches is described by Avid in this document : ...

    • Quick Start – Q-SYS Plugin for Luminex GigaCore Switches

      Introduction The Luminex GigaCore Q-SYS plugin allows monitoring and configuration of Luminex GigaCore Gen 2 switches directly from a Q-SYS design. The plugin is available here: https://github.com/luminex-lce/gigacore-q-sys-plugin The plugin ...