Minimum system requirements for Araneo

Minimum system requirements for Araneo

Minimum system requirements to install and run Araneo:

System requirements to run Araneo v1.9.0

Windows:

  1. OS: Windows 10 (64-bit), Windows 11
  2. Processor: x64 (64-bit operating system)
  3. RAM: minimum 4GB
  4. Free hard disk space: minimum 300MB
  5. Screen resolution: minimum 1280x900

Mac OS:

  1. OS: macOS 11 Big Sur, 12 Monterey, 13 Ventura, 14 Sonoma, 15 Sequoia
  2. RAM: minimum 4GB
  3. Free hard disk space: minimum 300MB
  4. Screen resolution: minimum 1280x800

Network:

Traffic that should be allowed:

  • Incoming
    • UDP 5353 (mDNS)
    • UDP 19243 (RLinkX)
    • UDP 30020 and 30021 (MA-Net 3)
  • Outgoing
    • TCP 80 (HTTP)
    • ICMP

    • Related Articles

    • Show additional edge device information in Araneo based on LLDP

      Introduction Starting from Araneo version 1.9.0, Araneo will show additional information of edge devices if the edge devices support LLDP (Link Layer Discovery Protocol). If the LLDP information contains an IPv4 management address, it is possible to ...

    • Araneo empty screen - New install of version 1.4.0

      It has been brought to our attention that some users are experiencing a disply issue with Araneo 1.4.0. It results in an empty interface at startup. This is a bug in the graphic rendering engine that occurs with older Intel HD Graphics cards.  A ...

    • Fix: ssh issue on updated mac os

      Customer cannot get access to SSH communication with a Gigacore. Error: "no matching key exchange method found. Their offer: diffie-hellman-group1-sha1" Fix 1 - Put the attached file on your desktop 2- Launch the terminal 3 - Run  # cp ...

    • Support For Allen & Heath systems - GigaAce and DX

      Introduction With default settings, it is not possible to have a Allen and Heath system run reliably on GigaCore switches. In a nutshell, it is because GigaAce and DX protocols rely on packet interval time to achieve clock synchronization. This means ...

    • How to reset Luminode 1 and 2

      Resetting a LumiNode or LumiCore can be done through various ways: - Web interface - LCD interface (if applicable) - Araneo - Luminet Monitor This guide is made for devices without LCD interface: LumiNode1, LumiNode2, LumiNode4DIN, but the same ...