LumiNode/LumiCore control channel values

LumiNode/LumiCore control channel values

In the LumiNode/LumiCore there are different functions where a control channel can be assigned. All values are in the range 0 - 255.
These are the control channel values for each of the available options:

General:
  1. 0 - 7: Do Nothing
Switch:
  1. 8 - 15: Input 1
  2. 16 - 23: Input 2
  3. 24 - 31: Input 3
  4. 32 - 39: Input 4
Play:
  1. 8 - 15: Go
  2. 16 - 23: Forward
  3. 24 - 31: Back
  4. 32 - 39: Reset
  5. 101 - 140: Record
Backup:
  1. 8 - 15: Recovery



    • Related Articles

    • LumiNode API documentation

      In the attached document you can find all the web API commands available for the LumiNode and LumiCore. The API is also available on the device itself by browsing to http://{YOUR_DEVICE_IP}/api/doc To highlight a couple of applications that are ...

    • Terminal block for contact closure on Luminode

      Have you lost the terminal block connector of your Luminode? The original part for the 2 pole terminal block shipped with : Luminode 2 Luminode 4 Luminode 12 Lumicore is : Wurth 691 361 300 002 ...

    • LumiNode/LumiCore Bitfocus Companion Streamdeck module

      Introduction Luminex products have an open HTTP API. This API can be used to integrate with other software applications. The LumiNode/LumiCore API is documented here. One such application is Bitfocus Companion, a software which enables the Elgato ...

    • LumiNode / LumiCore RSTP support

      LumiNode / LumiCore – RSTP Support and Updated Redundancy Behavior Minimal firmware version: v2.8 Introduction Starting from firmware v2.8, LumiNode and LumiCore devices have full support for Rapid Spanning Tree Protocol (RSTP). This significantly ...

    • LumiCore Advanced Networking

      In this article we will look at how to configure the network and advanced network options of the LumiCode. Firmware 2.3.0 or higher is required for these features. The interface has been redesigned in firmware 2.5.0. The configuration for LumiNode is ...