GigaCore RJ45 serial Connection on the console port

GigaCore RJ45 serial Connection on the console port

RJ45 serial pinout:
Pin 4,5: GND
Pin 3: RX (Data going to the GigaCore)
Pin 6: TX (Data out of the GigaCore)
Signal levels are RS232!

Serial connection settings:
Speed: 115200
Data bits: 8
Stop bits: 1
Parity: None
Flow Control: None

    • Related Articles

    • GigaCore switches Fiber Optic cabling

      This document will describe how to connect all your network devices via fiber optic and what to look out for on hardware level. SFP Technical Info In order to connect all the fiber links in the correct order we need to know which side of the SFP ...
    • Gigacore Switches and Avid S6L

      As most of you probably know by now, Gigacore switches can be used to connect the different units in an Avid S6L system. The procedure to configure Gigacore switches is described by Avid in this document : ...
    • What are the default credentials of a GigaCore?

      By default, any GigaCore switch will use the following: Login: admin Password: no password, leave the field blank
    • LumiNode LED indicators

      There are various LEDs on the LumiNode. Here is a list of the LEDs, the possible colours, and the meaning of each colour: DMX Port Status Meaning DMX Input Green Blinking: Active input DMX only (output mode) Cyan Blinking: DMX activity DMX + RDM ...
    • Can I transport AES50 audio protocol through the GigaCore?

      AES50 is an open standard based on the AES10 protocol (MADI) but has been developed much further. Published by the Audio Engineering Society AES, this protocol is using Cat5 cabling for transport. However, the protocol is not Ethernet compliant, this ...