GigaCore Generation 1 devices

• Related Articles

• GigaCore Generation 2 devices

  The GigaCore range of switches consist of 2 generations of products, built on different hardware platforms. The following devices are part of the GigaCore Generation 2 range of products : GigaCore 10i GigaCore 16i GigaCore 30i GigaCore 16t GigaCore ...

• GigaCore Bitfocus Companion Streamdeck module

  Introduction Luminex products have an open HTTP API. This API can be used to integrate with other software applications. The GigaCore API is documented here (generation 2) and here (generation 1). One such application is Bitfocus Companion, a ...

• GigaCore Gen2 API documentation

  In the attached document you can find all the web API commands available for the second generation GigaCore. The API is also available on the device itself by browsing to http://{YOUR_DEVICE_IP}/api/doc This API works for Gen2 GigaCore switches. All ...

• AVB / Milan

  GigaCore switches support AVB / Milan. In the current firmware versions (as of writing: GigaCore v1.4.1 of gen2 and GigaCore v3.1.0 for gen1), AVB is enabled by default on all ports. Enabling AVB on GigaCore To enable AVB on second generation ...

• MultiLinkX link aggregation

  Introduction MultiLinkX is Luminex's link aggregation protocol. It is based on the standard IEEE Link Aggregation Control Protocol (LACP). Other terms for link aggregations are 'trunking', 'bonding' or 'bundling'. With MultiLinkX, multiple physical ...