GigaCore Gen2 API documentation

GigaCore Gen2 API documentation

In the attached document you can find all the web API commands available for the second generation GigaCore.

The API is also available on the device itself by browsing to http://{YOUR_DEVICE_IP}/api/doc

This API works for Gen2 GigaCore switches. All supported models are listed here.

This API does NOT work for the first generation GigaCore's. A list of commands for these devices is available here: https://support.luminex.be/portal/en/kb/articles/gigacore-http-commands.
  1. GigaCore26i
  2. GigaCore16Xt
  3. GigaCore16RFO
  4. GigaCore14R
  5. GigaCore12
  6. GigaCore10

To highlight a couple of applications that are utilizing this API:
  1. Luminex Araneo software
  2. Bitfocus Companion and Buttons for Streamdeck
  3. SKAARHOJ GigaCore integration
  4. SpectralBot AR monitoring
  5. Meinberg / PTP Track Hound
  6. ...

    • Related Articles

    • LumiNode API documentation

      In the attached document you can find all the web API commands available for the LumiNode and LumiCore. The API is also available on the device itself by browsing to http://{YOUR_DEVICE_IP}/api/doc To highlight a couple of applications that are ...

    • GigaCore Bitfocus Companion Streamdeck module

      Introduction Luminex products have an open HTTP API. This API can be used to integrate with other software applications. The GigaCore API is documented here (generation 2) and here (generation 1). One such application is Bitfocus Companion, a ...

    • What are the default credentials of a GigaCore? (Gen 1 and Gen 2)

      By default, any GigaCore switch will use the following: Login: admin Password: no password, leave the field blank

    • Quick Start – Q-SYS Plugin for Luminex GigaCore Switches

      Introduction The Luminex GigaCore Q-SYS plugin allows monitoring and configuration of Luminex GigaCore Gen 2 switches directly from a Q-SYS design. The plugin is available here: https://github.com/luminex-lce/gigacore-q-sys-plugin The plugin ...

    • Gigacore (Gen 1) HTTP Commands

      In this article, wedescribe http commands you can use to gather informations from a Gigacore (Gen1)switch and apply some settings https://support.luminex.be/portal/en/kb/articles/gigacore-generation-1-devices http://<switch IP>/config/group_port GET: ...