Audinate Dante

Audinate Dante

All the groups on Luminex switches are configured to work with the Audinate Dante audio protocol out-of-the-box, no additional configuration is needed.
  1. GigaCore switches are managed switches with a friendly user interface. The Araneo software can be used to manage and monitor all GigaCore switches in a network at the same time.
  2. Energy Efficient Ethernet (EEE, Greeen Ethernet,...) is not available on GigaCore since it interferes with a lot of AV protocols
  3. All GigaCore switches are at least 1Gbps capable. Select models have 10Gbps SFP+ ports which can be helpful for higher-bandwidth trunks.
  4. GigaCore switches have a non-blocking siwtching capacity. Each port can run at full speed in both directions (TX / RX).
  5. GigaCore DSCP / QoS settings are pre-configured to work with Dante. More information about the QoS settings is available here.
  6. IGMP snooping and IGMP querier are enabled in all groups (VLANs) by default. It is easy to select a hierarchy of IGMP querier switches. Araneo recognizes the Dante-related IGMP subscriptions and shows these in the IGMP table:



    • Related Articles

    • QoS : DSCP Mapping Table

      QoS - DSCP Mapping All GigaCore models come with a default QoS mapping scheme that fits to the common multimedia protocols like AVB / Milan, Dante, AES67,... This scheme allows all these protocols to live together in a converged network. DSCP/Class ...

    • Gigacore Switches and Avid S6L

      As most of you probably know by now, Gigacore switches can be used to connect the different units in an Avid S6L system. The procedure to configure Gigacore switches is described by Avid in this document : ...

    • GigaCore API documentation

      In the attached document you can find all the web API commands available for the second generation GigaCore. The API is also available on the device itself by browsing to http://{YOUR_DEVICE_IP}/api/doc This API works for the following devices: ...

    • GigaCore Bitfocus Companion Streamdeck module

      Introduction Luminex products have an open HTTP API. This API can be used to integrate with other software applications. The GigaCore API is documented here (generation 2) and here (generation 1). One such application is Bitfocus Companion, a ...

    • GigaCore RJ45 serial Connection on the console port

      RJ45 serial pinout: Pin 4,5: GND Pin 3: RX (Data going to the GigaCore) Pin 6: TX (Data out of the GigaCore) Signal levels are RS232! Serial connection settings: Speed: 115200 Data bits: 8 Stop bits: 1 Parity: None Flow Control: None